The following steps outline the installation procedure:
1.Remove the factory ECU from the vehicle: Ensure the key is in the OFF position. The factory ECU is located on the left hand side of the left hand footwell. Remove the 6mm bolts (10mm socket) that retain the ECU and Unplug the wiring harness from the factory ECU. Remove the ECU from the vehicle. DO NOT touch the exposed pins in the factory ECU connector.
2.Remove the factory ECUs circuit board from its enclosure: Ensure you are following the given anti-static guidelines and ARE WEARING A CONDUCTIVE WRIST STRAP connected to a conductive working surface. Note there are two smaller bolts on the side of the ECU that clamp components to the case which need to be loosened.
3.Connect the ECU USB tuning cable and the expansion loom if required.
4.Install the Link ECU circuit board into the enclosure, then fit the enclosure into the vehicle.
5.Connect the ECU to the factory wiring loom.
6.Do NOT attempt to start the vehicle. Proceed to read through the remaining sections of this manual first.