This section only applies when an Intake Air Temperature (IAT) sensor has been wired and fitted to the intake system. It is important that the ECU is calibrated to match the sensor installed in the engine. This procedure is as simple as selecting the correct sensor type as follows:
1.Connect a laptop/notebook PC to the ECU and connect to the ECU using PCLink.
2.Click on 'Analog Channel' in the configuration tree.
3.Select the An Temp channel the sensor has been wired to.
4.Ensure that channel (and only that channel) is set to 'Inlet Air Temperature'.
5.Select the correct 'Temp Sensor Type'.
6.Select the 'Analog Inputs' tab in the runtime values section of PCLink (lower part of the screen).
7.Ensure that IAT reads the correct temperature.
8.Perform a 'Store' by pressing F4.