Note: This function is only available when using Multi-Point Group and Group/Staged Injection Modes.

 

This setting determines the number of injection drives that will be used when running group fire injection. This allows unused injection channels to be use as auxiliary outputs. Four options are available:

 

·INJ1-2 - Drives 1 and 2 are used for injection, the rest are available as auxiliary outputs.

·INJ1-4 - Drives 1 to 4 are used for injection, the rest (if any) are available as auxiliary outputs.

·INJ1-6 - Drives 1 to 6 are used for injection, the rest (if any) are available as auxiliary outputs.

·INJ1-8 - Drives 1 to 8 are used for injection.

 

Multi-Point Group Injection Mode

 

In group fire mode injection channels are fired in groups of odd and even numbered injection channels in anti-phase. Injectors should be wired distributed in even numbered groups across the injection drives. Refer to the wiring and installation manual for injection wiring.

 

Group/Staged Injection Mode

 

In Group Staged mode primary injectors must be wired to odd numbered injection drives, secondary injectors must be wired to even numbered injection drives. Refer to the wiring and installation manual for injection wiring.