DISCLAIMER
These setting are provided as a general guide only. It is the installers/tuners responsibility to check and confirm that all of these settings are correct for the application.
Engine specific setup information EJ25 AVCS variable intake cams:
Configuration |
||||||||||||||||||
4 Stroke |
||||||||||||||||||
4 |
||||||||||||||||||
1 - 3 - 2 - 4 |
||||||||||||||||||
Ignition Setup |
||||||||||||||||||
Direct Spark |
||||||||||||||||||
Falling (Dwell Edge = Rising) |
||||||||||||||||||
115 us |
||||||||||||||||||
Trigger Setup |
||||||||||||||||||
Subaru EJ25 AVCS |
||||||||||||||||||
Trigger 1 |
||||||||||||||||||
Reluctor |
||||||||||||||||||
Level 1 (Low) |
||||||||||||||||||
|
||||||||||||||||||
Trigger 2 (Wired to Bank 1 Inlet Cam Position Sensor) |
||||||||||||||||||
Optical/Hall |
||||||||||||||||||
ON |
||||||||||||||||||
Falling |
||||||||||||||||||
VVT Control |
||||||||||||||||||
Subaru AVCS EJ25 |
||||||||||||||||||
250 Hz |
||||||||||||||||||
Cam Position Sensors |
||||||||||||||||||
ON |
||||||||||||||||||
Falling |
||||||||||||||||||
Other Notes:
Fuel pump speed control should be done by wiring a spare Auxiliary or Aux-Ign output (but not Aux-Fuel) output to the fuel pump speed controllers signal wire. Set this output to FP Speed and select the Subaru V7-9 mode. Set Low-> at 20% and Med->High to 40%.
Recommended Knock Filter (Bosch aftermarket sensor): 6kHz Narrow Band Filter.
Recommended Knock Filter (factory sensor): 13kHz Narrow Band Filter.
For more information or corrections to this information please contact tech support.